Supero SUPERSERVER 6016TT-TF User Manual page 54

S S
UPER ERVER 6016TT-TF/6016TT-IBXF/6016TT-IBQF User's Manual
CMOS Clear
JBT1 is used to clear CMOS (which will also clear any passwords). Instead of pins,
this jumper consists of contact pads to prevent accidentally clearing the contents
of CMOS.
To Clear CMOS
1. First power down the system and unplug the power cord(s).
2. With the power disconnected, short the CMOS pads with a metal object such
as a small screwdriver.
3. Remove the screwdriver (or shorting device).
4. Reconnect the power cord(s) and power on the system.
Note: Do not use the PW_ON connector to clear CMOS.
VGA Enable/Disable
JPG1 allows you to enable or disable
the VGA port. The default position is on
pins 1 and 2 to enable VGA. See the
table on the right for jumper settings.
Watch Dog Enable/Disable
JWD1 enables the Watch Dog func-
tion, a system monitor that takes action
when a software application freezes
the system. Jumping pins 1-2 will
have Watch Dog reboot the system if a
program freezes. Jumping pins 2-3 will
generate a non-maskable interrupt for
the program that has frozen. See the
table on the right for jumper settings.
Watch Dog must also be enabled in
BIOS.
VGA Enable/Disable
Jumper Settings (JPG1)
Jumper Setting
Pins 1-2
Pins 2-3
Jumper Settings
Jumper Setting
Pins 1-2
Pins 2-3
Open
Note: when Watch Dog is enabled, the user must
write their own application software to disable the
Watch Dog Timer.
5-20
Defi nition
Enabled
Disabled
Watch Dog
Defi nition
Reset
NMI
Disabled