Supero SUPERSERVER 6016TT-TF User Manual page 44

S S
UPER ERVER 6016TT-TF/6016TT-IBXF/6016TT-IBQF User's Manual
DIMM DIMMs
Slots per Populated
Channel per Channel
2 1
2 1
2 2
2 2
To Install: Insert module
vertically and press
down until it snaps into
place. Pay attention to
the alignment notch at
the bottom.
To Remove:
Use your thumbs to
gently push the release
tabs near both ends of
the module. This should
release it from the slot.
RDIMM Population with 5500 Processors Installed
DIMM DIMMs
Slots per Populated
Channel per Channel
2 1
2 1
2 2
2 2
Note 1: 1333 RDIMMs will run at 1066 MHz (BIOS automatic downgrading).
Note 2: 1333/1066 RDIMMs will run at 800 MHz (BIOS automatic downgrading).
UDIMM Population with 5500 Processors Installed
DIMM DIMMs
Slots per Populated
Channel per Channel
2 1
2 2
Note: 1333 UDIMMs will run at 800 MHz (BIOS automatic downgrading)
DIMM Population Table
DIMM Type (Reg.= Speeds (in MHz)
Registered)
Reg. DDR3 ECC 800,1066,1333
Reg. DDR3 ECC 800,1066,
Reg. DDR3 ECC 800,1066,1333
Reg. DDR3 ECC 800,1066
Figure 5-3. DIMM Installation
Notch
Release Tab
DIMM Type (Reg.= Speeds (in MHz)
Registered)
Reg. DDR3 ECC 800,1066,1333
Reg. DDR3 ECC 800,1066 (Note 1)
Reg. DDR3 ECC 800,1066 (Note 1)
Reg. DDR3 ECC 800 (Note 2)
DIMM Type (Unb.=
Unbuffered)
Unb. DDR3 ECC/Non-ECC
Unb. DDR3 ECC/Non-ECC
5-10
Ranks per DIMM
(any combination;
SR=Single Rank,
DR=Dual Rank,
QR=Quad Rank)
SR, DR
QR
SR, DR
SR, DR, QR
Front View
Note: Notch should align
with the receptive key
point on the slot.
Ranks per DIMM
(any combination;
SR=Single Rank,
DR=Dual Rank,
QR=Quad Rank)
SR or DR
QR
Mixing SR, DR
Mixing SR, DR, QR
Speeds (in MHz) Ranks per DIMM
(any combination;
SR=Single Rank,
DR=Dual Rank,
QR=Quad Rank)
800,1066,1333 SR or DR
800,1066 (Note) Mixing SR, DR
Notch
Release Tab