Sending A Fax At A Specified Time (Timer) - Sharp MX-FXX1 Manual

SENDING A FAX AT A SPECIFIED TIME (Timer)

When this function is used, transmission takes place automatically at a specified time.
The timer transmission function makes it easy to perform reserved transmissions, broadcast transmissions and other
transmissions at night or other times when phone rates are low.
A timer setting can also be specified for polling reception to receive a fax when you are not present.
Set a broadcast transmission
in the daytime to take place at
20:00
• When timer transmission is set, always keep the main power switch in the "On" position. Transmission will not take place if
the main power is off at the specified time.
• When performing a timer transmission, you must scan the original into memory when you set up the transmission. It is not
possible to leave the document in the auto document feeder or on the document glass and have it scanned at the reserved
time of transmission.
• When the transmission is finished, the transmission settings (resolution, destinations, etc.) will be erased. However, the
selected settings and transmitted fax image are stored if the document filing function is used.
☞
Document Filing Guide
1
Ready to send.
Scan
Fax
Mode Switch
A4
Image
2
Settings
Memory TX
Direct TX
Auto Reception
Fax Memory:100%
Speaker Resend
Send
Address Book
Auto
Sub Address
Special Modes
Quick File
At 20:00, the broadcast
transmission begins automatically
(Transmission to the first destination
takes place)
Place the original.
Place the original face up in the document feeder tray, or face
down on the document glass.
Touch the [Special Modes] key.
File
66