Changing The Transaction Report Print Condition For A Single Transmission - Sharp MX-FXX1 Manual

CHANGING THE TRANSACTION REPORT PRINT
CONDITION FOR A SINGLE TRANSMISSION
When performing a transmission, follow the steps below to select the condition for printing a transaction report. When
the transmission is finished, your setting will be cleared.
Ready to send.
Scan
Fax
Mode Switch
A4
Image
1
Settings
Memory TX
Direct TX
Auto Reception
Fax Memory:100%
Fax
Special Modes
Transaction
Report
2
Polling
(2)
Special Modes
Transaction Report
Always Print
Print Original Image
3
• The print conditions for a transaction report are as follows:
"Always Print": A transaction report is printed no matter whether the transmission succeeds or fails.
"Print at Error": A transaction report is printed when transmission fails.
"Do not Print": Do not print a transaction report.
• When the [Print Original Image] checkbox is selected (
transaction report. However, the original image is not printed when dialling using the speaker, a direct transmission
or polling operation is performed.
• To return to the screen of step 2, touch the [OK] key next to the [Cancel] key.
For a broadcast transmission, the print condition applies to each destination.
Speaker Resend
Send
Address Book
Auto
Sub Address
Special Modes
Quick File
Own Name
Select
Memory Box
(1)
Cancel
Print at Error Do not Print
Touch the [Special Modes] key.
File
Display the transaction report print
OK
settings screen.
2/3
(1) Touch the
the screens.
(2) Touch the [Transaction Report] key.
(1)
Select the transaction report print
(2)
condition.
OK
(1) Touch the key of the desired print
OK
condition.
(2) Touch the [OK] key.
), part of the transmitted original is included on the
58
keys to switch through