TEC BRST-10 SERIES Owner's Manual page 21

7. REPLACING THE INK CARTRIDGE
4. Unpack a new ink cartridge. Pull down both arrow sections remove the protection pad from the
cartridge.
NOTES: 1. Do not touch the ink outlet on the bottom of the ink cartridge with your fingers or any
objects.
2. To avoid the ink cartridge from which the protection pad has been removed from getting
dry, install it into the head unit as soon as possible after removing the protection pad.
3. Do not drop or shake the head unit/ ink cartridge. Doing so may cause ink to spill over.
Once ink gets on your clothes, it cannot be removed.
5. Insert the ink cartridge into the head unit so that the black and yellow arrows on the ink cartridge line
up with the black and yellow arrows on the carriage.
NOTE: When installing the ink cartridge into the head unit, fully push the ink cartridge until the hook
secures the cartridge.
Head Unit
Carriage
6. Depress the [CARTRIDGE] switch.
The printer performs the initial operation. After the initial
operation is finished, the carriage returns to the home position
(right end), and the power LED stops blinking and remains
on.
7. Insert the two hooks into the holes on the top cover, and then
close the printer cover slowly. The ERROR LED turns off,
and the printer becomes ready to print.
NOTE: Failure to close the printer cover fully may cause an
error condition.
Black arrow
Hook
7-2
7. REPLACING THE INK CARTRIDGE
Protection Pad
Ink Cartridge
Yellow arrow
EO1-13013
Fig. 7-3
Fig. 7-4