Table of Contents
Advertisement
5. INSTALLATION PROCEDURE
3. Load the receipt roll into the paper holder as the figure shows. 2
4. Insert the receipt straight into the receipt inlet. 3
The auto loading mechanism feeds and cuts the receipt automatically.
NOTE: If the rear paper release lever is not pushed down, the
auto loading mechanism does not perform.
The ERROR LED turns off, and the printer becomes ready to
print.
Receipt Inlet
5. Close the paper cover slowly.
Receipt Roll
Paper Cover
3
Rear Paper Release
Lever (blue)
5-5
5.3 LOADING THE RECEIPT ROLL
NOTE:
Set the receipt roll in correct
direction.
Cut the paper end to make it
sharp.
EO1-13013
Fig. 5-8
Fig. 5-9
Advertisement
Table of Contents
