Table of Contents
Advertisement
7. REPLACING THE INK CARTRIDGE
7. REPLACING THE INK CARTRIDGE
The INKOUT LED on or blinking shows that ink is getting
low. The printer can print until ink is fully finished, however,
please replace the ink cartridge with a new one earlier.
1. To avoid injury and printer damage, be careful not to catch your fingers or any objects while
the carriage moves right and left in the initial performance.
2. Please be careful when handling ink cartridges, not to get ink on your hands or in your eyes.
If you accidently get ink on your hands wash them with soap and water. If any ink should get
into your eyes immediately flush them out with clear water.
CAUTION:
1. Do not put anything on the printer cover and never press on it.
2. Do not drop or shake the head unit/ ink cartridge. Doing so may cause ink to spill over. Once
ink gets on your clothes, it cannot be removed.
1. Remove the printer cover. (Refer to 5.2 LOADING THE HEAD UNIT/ INK CARTRIDGE.)
2. Depress the [CARTRIDGE] switch for 3 seconds.
By this operation, the carriage moves to the head unit/ ink
cartridge replacement position.
NOTES: 1. If the printer cover is closed, the carriage will
not move to this position by this operation.
2. Never perform this operation except for the
ink cartridge replacement.
Carriadge
3. While pushing the hook in direction 1, remove the ink cartridge from the head unit in diretion 2.
Ink Cartridge
WARNING!
2
1
7-1
7. REPLACING THE INK CARTRIDGE
Fig. 7-1
Hook
EO1-13013
Fig. 7-2
Advertisement
Table of Contents
