Loading The Receipt Roll - TEC BRST-10 SERIES Owner's Manual

5. INSTALLATION PROCEDURE
6. Depress the [CARTRIDGE] switch.
The printer performs the initial operation. After the initial
operation is finished, the carriage returns to the home
position (right end).
7. Insert the two hooks into the holes on the top cover, and then close the printer cover slowly.

5.3 LOADING THE RECEIPT ROLL

1. Open the paper cover toward the rear 1.
2. Cut off both adhesive areas of a new receipt roll.
NOTE: Do not insert the receipt paper with adhesive portions into the printer. If so, adhesive will
attach to the feed roller. This may cause a slant print or a paper jam.
Adhesive
Adhesive
5-4
5.3 LOADING THE RECEIPT ROLL
Printer Cover
Hooks
Top Cover
Fig. 5-6
Fig. 5-7
EO1-13013