Troubleshooting Table - Travis Industries DVL GSR Insert Owner's Manual

40

Troubleshooting Table

Problem:
Main Burners Will Not
Start
Receiver Beeps
Thermostat Does Not
Work
Heater Will Not
Distribute Heat
Flames Are Too Blue
Flames Are Too Short
(Under 6")
Thin Layer of Soot
Covers the Glass
© Travis Industries
Maintenance
Possible Cause:
The receiver is turned to "OFF"
The remote control is not working correctly
No Propane in Tank
The power backup batteries are dead
The receiver is turned to "OFF"
The thermostat is set too low
The heater is not getting electricity
The heater is not up to temperature
The heater has just been started
Improper air shutter adjustment
The flame height may be turned too low
The logs or coals are placed incorrectly
Improper air shutter adjustment
Turn the receiver switch to "ON"
See the remote control instructions
Check Tank Level
Replace the batteries (see page 38)
Turn the receiver switch to "ON"
Check thermostat
Check the breaker switch
Let the heater burn for at least 15 minutes
This is normal - see "Starting the Heater
for the First Time"
Adjust Air Shutter - contact your dealer
Turn the flame height to "HI" -
See "Adjusting the Flame Height"
See "Log Set Installation"
Adjust Air Shutter - contact your dealer
4091008
Don't Call for Service
Until You:
100-01236_000