Table of Contents
Advertisement
6. Time and snooze alarm
7. Time of day
8. Date
9. day of week
10. MIN/MAX icon
11. transmitter reception (flashes when received)
The normal display mode is as shown in Figure 9.
1.5
Sensor Operation Verification
Verify the indoor and remote (water) temperature matches closely
while in the same location. The sensors should be within 3°C (the
accuracy is ± 3°C). Allow about 30 minutes for both sensors to
stabilize.
3. Remote Sensor Installation
Place the remote sensor into the water (pool, spa, etc). The
temperature will take a few hours to stabilize. There is bracket on the
thermometer to optionally tether the float.
Version 1.4
Figure9
Page 7
Advertisement
Table of Contents
