Kogan KAPOLTHERMA User Manual page 5

Figure 3
4. Channel Number: The display console supports up to three
transmitters. To set each channel number (the default is Channel
1), change Dip Switches 1 and 2, as referenced in Table 1.
5. Temperature Units of Measure: To change the transmitter
display units of measure (°F vs. °C), change Dip Switch 3, as
referenced in Table 1(the default is °C).
DIP SWITCH
1
DOWN
UP
DOWN
---
---
Table 1
6. Verify the correct channel number (CH) and temperature units of
measure (°F vs °C) are on the display, as shown in and Figure
5.
Figure 4
Note: The following illustration shows the full segments of the
transmitter LCD for description purposes only and will not appear
like this during normal operation.
Version 1.4
2 3
DOWN ---
DOWN ---
UP ---
--- DOWN
--- UP
Page 4
FUNCTION
Channel 1 (factory
default setting)
Channel 2
Channel 3
°F
°C (factory default
setting)
Figure 4