Table of Contents
Advertisement
Figure 6
1. Transmitter channel number
2. Water temperature
3. Water temperature units (°F vs. °C)
4. Transmitter indication (flashes when sent)
Verify the gasket is properly seated in the guide on transmitter cover.
Twist on the transmitter cover (clockwise), as shown in Figure 7.
Figure 7
1.3
Display Console Set Up
Note: To avoid permanent damage, please take note of the battery
polarity before inserting batteries.
Remove the battery door on the back of the display. Insert two AAA
(alkaline or lithium, avoid rechargeable) batteries in the back of the
display console.
All of the LCD segments will light up for a few seconds to verify all
segments are operating properly, and the unit will beep.
Replace the battery door, and fold out the desk stand and place the
console in the upright position.
The console will instantly display indoor temperature, and the default
date and time. The thermometer transmitter will display --, then
Version 1.4
Page 5
Advertisement
Table of Contents
