Vertex Standard Pilot VXA-210 Operating Manual page 44

03 [ RESM ]
Function: Scan-Resume Mode Setting
Available Values: CAR/5
Default Setting: CAR
In the "CAR" (Carrier Drop) mode, the scanner will
remain halted for as long as there is a carrier present
on the channel; after the carrier drops at the end of
the other station's transmission, the scanning will
resume.
In the "5" (5-Second Pause) mode, the scanner will
halt for five seconds only, after which scanning will
resume (whether or not the other station is still trans-
mitting).
04 [ SCNL ]
Function: Scan Lamp On/Off (while paused)
Available Values: on/oFF
Default Setting: on
If you set this function to "on," the lamp will be illu-
minated whenever the scanner pauses. The lamp will
go off automatically when scanning resumes.
42
( )
M "S " M
ENU ET
05 [ BEEP ]
Function: Keypad Beeper On/Off
Available Values: on/oFF
Default Setting: on
If you do a lot of scanning, you may wish to set this
Menu item to "oFF," as the Beeper will be heard each
time the scanner pauses.
06 [ RSAV ]
Function: Receive Battery Saver
Available Values: 1:1 ~ 1:5/oFF/ABS
Default Setting: 1:1
The setting of 1:5 will promote the greatest conser-
vation of battery capacity, but the receiver's response
time to incoming calls will be slowed somewhat.
øABS: Automatic Battery Saver, based on activity
on the receiver.
Note: This feature does not operate during Scan or
Dual Watch.
VXA-210 P
ODE
O
ILOT PERATING
ø
M
ANUAL