Vertex Standard Pilot VXA-210 Operating Manual page 15

To set 118.275 MHz, you do not need to press
the final "5" in the frequency:
[ 1 ] à [ 1 ] à [ 8 ] à [ 2 ] à [ 7 ] .
r You may also turn
the top panel's DIAL
selector knob to
choose the desired
operating frequency.
The channel fre-
quency will appear
on the LCD.
r T o c h a n g e f r e -
quency in 1 MHz
steps, press the [ F ]
key momentarily,
then rotate the DIAL
selector knob to se-
lect the MHz digit
desired. Press [ F ] once more to resume normal
channel selection in 25-kHz steps.
VXA-210 P O
ILOT PERATING
O
PERATION
r Rotate the VOL-
F
+
r Press and hold the
M
ANUAL
UME knob to set the
volume level. If no
signal is present,
press and hold the
MONITOR button
for 2 seconds; back-
ground noise will
now be heard, and
you may use this
noise to set the
VOLUME knob for
the desired audio
l e v e l . P r e s s t h e
MONITOR button momentarily to silence the
noise and resume normal (quiet) monitoring.
LAMP button for 2
seconds, to illumi-
nate the display con-
tinuously. To disable
the illumination,
press the LAMP but-
ton momentarily.
13