Operation; Preliminary Steps; Operation Quick Start - Vertex Standard Pilot VXA-210 Operating Manual

Preliminary Steps

¦ Install a charged battery pack onto the transceiver,
as described previously.
¦ Screw the supplied antenna onto the Antenna
jack. Never operate this transceiver without an
antenna connected.
¦ If you have an optional Speaker/Microphone or
headset, we recommend that it not be connected
until you are familiar with the basic operation of
the VXA-210.
12
O
PERATION

Operation Quick Start

r To turn the radio on,
rotate the VOLUME
knob out of the
click-stop.
r After three "initial-
ization" beeps are
heard, a channel fre-
quency should ap-
pear on the display.
If not, press down-
ward (momentarily)
on the DIAL selector knob (repeatedly, if neces-
sary) so that " - VFO - " appears on the display,
followed by a channel frequency.
r Directly entering frequencies from the keypad is
the easiest method if you know the frequency on
which you wish to operate. Just enter the five
digits of the frequency to move to that frequency.
For example, to set 134.35 MHz,
press [ 1 ] à [ 3 ] à [ 4 ] à [ 3 ] à [ 5 ] .
VXA-210 P O M
ILOT PERATING ANUAL
Press