Connecting The Am Loop Antenna; Connecting The Speakers - Kenwood R-K711 Instruction Manual

Microcomputer malfunctions

Connecting the AM loop antenna

The antenna supplied with the system is for indoor use. Place it as far as possible away from the main unit, your
TV set, the speaker cords and the power cord and point it in the direction that gives the best reception.
Connecting the antenna cord
Connect the AM antenna cord to the [AM]
and [MGND] terminals, as shown on the
right.
Connecting the FM indoor antenna
The antenna supplied with the system is a basic antenna for indoor use. For stable signal reception, the use
of an outdoor antenna (commercially available unit) is recommended. To connect an outdoor antenna, fi rst
remove the indoor antenna.

Connecting the speakers

Notes on connecting the
speaker cords
Preparing the ends of the speaker cords
Twist the plastic sleeve on the end of the cord as you
pull it off .
Connecting the speaker cords
1
If the system is connected correctly and still does not operate
normally or shows display errors, reset the microcomputer. (P.75)
1
Never short-circuit the positive (+) and negative (–) ends of
the speaker cords. (Do not touch the + and – cords together.)
Mistakenly reversing the positive and negative polarity will
result in unnatural sound and unclear sound source (e.g. musical
instruments) locations.
2 3
Connecting the System
2 3
4
11
English