Kenwood KRF-V6400D Instruction Manual page 19

How to connect the wire to terminals How to connect the wire to terminals
(Screw type terminal) (KRF-V6400D only) (Screw type terminal) (KRF-V6400D only)
1
Strip the vinyl coating of the wire by a length of
about 1 cm.
2
Loosen the knob.
3
Insert the wire.
Insert until the metallic conductor becomes invisible.
4
Tighten the knob.
How to connect the wire to terminals How to connect the wire to terminals
(Push type terminal) (Push type terminal)
1
Strip the vinyl coating of the wire by a length of
about 1 cm.
2
Push the lever.
3
Insert the wire.
Insert until the metallic conductor becomes invisible.
4
Release the lever.
19
English