Rear Panel Connections - Bel Canto S300i e.One Series User Manual

S300i Rear Panel Connections
S300i Rear Panel
Never Connect Either the Positive or Negative Speaker Output to Any
Ground Contact! Always remove power before changing any cable con-
nections to or from this product!
Connecting any Speaker Output on the S300i to Ground will cause the amplifier to go
into protection and could damage the amplifier and void the warranty.
Inputs 1-4 accept standard line level RCA
signal from any signal source. Input 5 is
an optional USB DAC or MM Phono input
module.
Line Out can be used to drive a powered
sub-woofer or second amplifier. It is con-
trolled by the front panel volume control.
Record Out is a fixed level pass-through of
whatever input is selected.
Speaker Output Connections: Attach your
loudspeakers to the output connectors.
Insure that the polarity of each speaker is
© 2006 bel canto design, Ltd.
correct and the same for both speakers.
IEC power cord jack: Connect a heavy-
gauge power cord from this jack to the
wall power supply. Note the power setting
indicated on the back of the integrated
amplifier before connecting the power.
When all connections to and from the
amplifier have been made double check
everything before plugging the S300i into
the power souce. The S300i will come up
in standby, indicated by a pair of dashes
on the front panel (- -).
page 9 S300i User's Guide 0906 Rev. A