Remote Control - Bel Canto S300i e.One Series User Manual

Mute: (available only on the
remote)
The S300i starts up in Soft Mute. This
level is 20dB below the displayed vol-
ume level. When MUTE is first pressed it
goes to the Soft state, indicated by 2
decimal points on the volume display
(i.e. 50.0.). Pressing MUTE again rapid-
ly will fully MUTE the outputs. Full mute
is indicated by 4 decimal points in the
volume display (i.e. .5.0.0.).
Pre In:
This is used to toggle through the inputs.
When initially pressed it will indicate the
currently selected input.
© 2006 bel canto design, Ltd.

Remote Control

page 7
Standby:
Used to toggle the S300i into and out of
standby mode. Standby hard mutes the
outputs while keeping all circuitry run-
ning, maintaining optimum circuit per-
formance. Before unplugging the S300i
from mains power it is recommended to
place it in standby first. Standby is indi-
cated by the presence of 2 dashes on
the display - - .
Do not make cable changes to or
from the S300i while the unit is
in standby. Always unplug the
S300i before making any cabling
changes. Damage caused by not
following this procedure is not
covered under warranty!
S300i User's Guide 0906 Rev. A