Smeg Oven Instructions For The User page 48

• Remove the guide frames, see "8.5.1
Removing guide frames".
• At the end of the cleaning cycle, when
the oven has cooled down, reinsert
the frames by repeating the previously
used procedure in reverse order.
• Make sure that the oven door is firmly
closed.
In order not to damage the internal glass panel, it should be cleaned in
accordance with the usual procedure (see 8.5 Cleaning the door glazing) before
starting the automatic cleaning cycle.
For very stubborn encrustations, lock the door using the pins provided and
remove the glass panel. Spray an oven cleaning product onto the glass (read
the warnings on the product); leave for 60 minutes, then rinse and dry the glass
using kitchen roll or a microfiber cloth. After carrying out these operations,
position the glass panel on the door again and remove the pins locking it.
Refer to the following diagram for setting the cleaning cycle duration:
CLEANING
DURATION
During the automatic cleaning cycle, the fans produce a more intense level of
noise due to a greater rotation speed; this is entirely normal and intended to
facilitate heat dissipation.
At the end of pyrolysis, the fans will continue to operate for long enough to avoid
overheating the walls of adjacent units and the front of the oven.
If the pyrolysis gives unsatisfactory results at minimum duration, it is
recommended to set a longer time for successive cleaning cycles.
50
Instructions for the user
LIGHT DIRT
120 MIN.
MEDIUM DIRT
150 MIN.
HEAVY DIRT
180 MIN.