Positioning In The Counter Top - Smeg Hob Instructions For The Installer

6. POSITIONING IN THE COUNTER TOP

The following operation requires building and/or carpentry work and must
therefore be carried out by a competent tradesman.
Installation can be carried out on various materials such as masonry, metal,
solid wood or plastic laminated wood as long as they are heat resistant (T
90°C).
6.1 Fixing to the traditional built-in model support structure
Create an opening with the dimensions
shown in the figure in the top surface of
the counter,
distance of 50 mm from the rear edge.
This appliance can be mounted against
walls higher than the worktop on
condition that a distance of "1" be kept
between the appliance and the wall as
shown in the figure so as to avoid
damage from overheating. Make sure
that there is a minimum distance of 750
mm between the stoves and any shelf
that may be installed directly above it.
Carefully
insulating seal
perimeter of the hole made in the
counter top as shown in the figure
below, trying to make it stick on the
entire surface by applying light pressure
on it with your hands. The front and rear
sides of the seal must brush against the
hole.
Once these operations have been
carried out, place the hob on the
insulating seal and fix it to the
supporting structure using screws and
fastening brackets so that the hob is
perfectly flat.
The brackets shown in the figure should
be placed only after the hob has been
built in.
12
Instructions for the installer
keeping a
position the
"2" on the outer
1
5 1
minimum
supplied
8 6
6
2
1 5
0
1
8 4
7
2
4 8
1 2
3 4
7 3
5 0