Positioning In The Counter Top - Smeg Hob Instructions For The User

Instructions for the installer

7. POSITIONING IN THE COUNTER TOP

The following operation requires building and/or carpentry work and must be
carried out by a competent tradesman.
Installation can be carried out on various materials such as masonry, metal,
solid wood or plastic laminated wood as long as they are heat resistant (T
90°C).
If installed on top of an oven, the latter must be equipped with a cooling fan.
7.1 Section cut from the work surface
Create an opening with the dimensions shown in the figure in the top surface of
the counter, keeping a minimum distance of 50 mm from the rear edge. This
appliance can be mounted against walls higher than the work surface on
condition that a distance X be kept between the appliance and the wall as
shown in the figure so as to avoid damage from overheating. Any wall units must
be at a minimum distance of at least 750 mm above the appliance. This distance
can be reduced to 650 mm if a ventilation hood is installed.
In case of installation on an empty kitchen unit with doors, a separation panel
must be placed under the hob. Keep a minimum distance of 10 mm between the
bottom of the hob and the surface of the panel, which must be easily extractable
to allow sufficient access for any technical assistance.
16