Vcr Auto Installation - Sharp DV-NC65H Operation Manual

VCR Auto Installation

This Unit automatically tunes the TV channels for your area, then
using Teletext information sorts the TV channels into a standard
order and sets the clock. If the Unit has not previously been tuned-in,
instructions will be given on screen to guide you through this proce-
dure.
1
Press OPERATE.
2
The screen below should now be displayed on your TV screen.
• If the AUTO INSTALLATION screen does not appear when you switch on
your VCR or you wish to reset your Unit and start the installation again,
refer to VCR RESET on page 38.
3
Press SET to continue with the installation.
4
Ensure your Aerial/Scart cables are connected to your Unit and
then press SET to confirm.
5
All available terrestrial channels will be automatically installed.
(Auto install may take a few minutes.)
6
Once Auto Installation is complete, the MOVE menu screen will
appear showing all the channels the Unit was able to tune in.
26
DVNC65H026_027.pm6
AUTO INSTALLATION
PRESS SET KEY TO START
SET :ENTER MENU:EXIT
PLEASE BE SURE THE
AERIAL/SCART CABLE IS
CONNECTED TO YOUR VCR.
PRESS SET TO CONTINUE
SET :ENTER MENU:EXIT
1 CH22
AUTOMATIC TUNING.
PLEASE WAIT.
SET :ENTER MENU:EXIT
www.sharp.co.uk/support
26
TIMER
OPERATE
VIDEO Plus+ EJECT
ON/OFF
ON VCR/DVD VCR MENU
DISPLAY
SCREEN SELECTOR DVD SETUP
FUNCTION PROG/ OPEN/
ANGLE
CONTROL REPEAT CLOSE
TITLE
DVD MENU
CLEAR SET
RETURN ENTER
ZERO BACK
SKIP SEARCH
TV/VCR
AM/PM INPUT SELECT VCR DVD
/
REV FWD
PLAY
REC
PAUSE/STILL
STOP
TAPE DPSS
SKIP SLOW
SPEED
AUDIO
CH
OUTPUT
VCR DVD
VCR/DVD COMBINATION
RRMCGA069WJSA
30/8/02, 11:27 am