Speaker Connection; Demonstration Mode - Sharp CD-E600H Operation Manual

! Speaker connection

Connect the black wire to the minus (-) terminal, and the red wire to
the plus (+) terminal.
Caution:
" Use speakers with an impedance of 6 ohms
or more, as lower impedance speakers can
damage the unit.
" Do not mistake the right and the left chan-
nels. The right speaker is the one on the right
side when you face the unit.
" Do not let the bare speaker wires touch
each other.
" Do not stand or sit on the speakers. You may
be injured.
! Placing the speaker system
The left and right speakers have individual shapes. For best perfor-
mance, place the speakers according to the diagram below.
Left speaker
Note:
The speaker grilles are not removable.
! Connecting the AC power lead
After checking all the connections have been made correctly, plug
the AC power lead of this unit into the wall socket. If you plug in the
unit first, the unit will enter the demonstration mode.
Notes:
" The unit will start the tape initialisation when plugged in to the AC
socket. During this process, initialising sound will be heard and
the unit cannot be turned on. Wait until the process is finished.
" Unplug the AC power lead from the wall socket if the unit will not
be in use for a prolonged period of time.

! Demonstration mode

The first time the unit is plugged in, the
unit will enter the demonstration mode.
You will see words scroll.
To cancel the demonstration mode:
Incorrect When the unit is in the power stand-by mode (demonstration mode),
press the X-BASS/DEMO button. The unit will enter the low power
consumption mode.
To return to the demonstration mode:
When the unit is in the power stand-by mode, press the X-BASS/
DEMO button again.
Note:
When the power is on, the X-BASS/DEMO button can be used to
Right speaker
select the extra bass mode.
! To turn the power on
Press the ON/STAND-BY button to turn the power on.
After use:
Press the ON/STAND-BY button to enter the power stand-by
mode.
02/12/24 CD-E600H(H)E1.fm
CD-E600H
ENGLISH
8
E-8