Sharp CD-E600H Operation Manual page 33

5
Press the TUNING/TIME ( or ) button to specify the hour
to start, then press the MEMORY/SET button.
The illustrations show the timer playback setting.
6
Press the TUNING/TIME ( or ) button to specify the min-
utes, then press the MEMORY/SET button.
The unit will enter the timer stand-by mode automatically.
To cancel the timer playback/timer recording:
Press the ON/STAND-BY button to turn the power on.
7
When the preset time is reached, playback or recording will
start.
The volume will increase gradually until it reaches the volume
you were listening to before your system entered the timer
stand-by mode.
In timer playback:
If you select CD or TAPE, the unit will enter the stand-by mode
after the playback. If you select TUNER, it will enter the stand-
by mode one hour after the timer playback starts.
In timer recording:
When the recording tape reaches its end, the timer recording
will end, and the unit will enter the stand-by mode.
To reset or change the timer setting:
Perform "Timer playback or timer recording" from the beginning.
Note:
When performing timer playback or recording using another unit
connected to the VIDEO/AUX IN sockets, select "VIDEO/AUX" in
step 2.
At this time, only this unit will be turned on or enter the power stand-
by mode automatically. It will enter the power stand-by mode when
the end of the recording tape is reached in timer recording or 1 hour
after the playback starts in timer playback. However, another unit
will not be turned on or off.
02/12/24 CD-E600H(H)E3.fm
CD-E600H
ENGLISH
8
E-26