Timer And Sleep Operation - Sharp CD-E600H Operation Manual

Timer and sleep operation (continued)
CD-E600H
ENGLISH
! Sleep operation
1
Play back the desired sound source.
2
Press the TIMER/SLEEP button repeatedly until "SLEEP" is
displayed.
To change the sleep time:
Whilst the sleep time is displayed, press the TUNING/TIME (
or ) button.
(Maximum: 3 hours - Minimum: 1 minute)
" 3 hours - 5 minutes
" 5 minutes - 1 minute
3
Press the MEMORY/SET button.
4
Your system will enter the power stand-by mode automat-
ically after the preset time has elapsed.
The volume will be turned down 1 minute before the sleep op-
eration finishes.
To cancel the sleep operation:
Press the ON/STAND-BY button whilst the sleep timer is set.
To confirm the remaining sleep time:
Press the TIMER/SLEEP button whilst the sleep timer is set.
The remaining sleep time is displayed for about 5 seconds.
E-27
5-minute intervals
1-minute intervals
! To use timer and sleep operation together
Example: To fall asleep and wake up to the same radio station
You can play back the same source only (the function cannot be
switched).
1
Set the sleep time (see left, steps 1 - 3).
2
Whilst the sleep timer is set, set the desired playback time
(steps 4 - 6, pages 25 - 26).
Sleep timer setting Timer playback setting
1 minute - 3 hours
Sleep operation will
automatically stop.
Caution:
When using the cassette deck, be sure the tape length is long
enough to perform both functions. If you want to sleep and wake up
listening to a tape, and the length of the tape is shorter than the
sleep timer setting, timer playback will not be possible.
02/12/24 CD-E600H(H)E3.fm
Timer playback
start time