Table of Contents
Advertisement
Cleaning the
accessories
Cooking
Gas burners
Setting procedure
Switch off
Note
Hob
Please wash the accessories with soapy water before
using them for the first time.
Make the heat setting using the control knobs.
The symbol above the hotplate control shows you to
which hotplate the control knob belongs.
S = Off setting
J = Large flame, highest setting
K = Ignition setting
I
= Economy flame, lowest setting
An end stop is fitted at the end of the setting range.
Please do not turn the switch beyond this point.
1.
Press the hotplate control, turn clockwise to the
ignition position K and keep depressed.
2.
After ignition, keep the control knob depressed for
5 seconds. Press firmly once more and then
release.
3.
Vary the flame size using the hotplate control.
Use large flame J for the boil start, then turn back
to the desired flame size.
Turn the hotplate control clockwise to the end stop S.
If ignition does not occur, turn the hotplate control
slightly clockwise towards the economy flame
setting I and press it once more.
The hob comes supplied with its own separate in
struction manual. Here you will find further information
with regards to appliance operation, care and clea
ning.
13
Advertisement
Table of Contents
