Before Using The Oven For The First Time; Heating Up The Oven; Setting Procedure For The Lower Gas Burner; Setting The Gas Grill - Siemens HU23351 M Series Instruction Manual

Before using the oven for the first time

In this section, you can find out what you must do before using
your oven or gas hob to prepare food for the first time. First
read the section on Safety information.

Heating up the oven

To remove the new cooker smell, heat up the oven when it is
empty and closed. Ensure that no packaging material has been
left in the cooking compartment.
Keep the kitchen ventilated the whole time the oven is on.

Setting procedure for the lower gas burner

Example in the picture: Heat at 270 °C
Open the top cover. The top cover must remain open for as
1.
long as the oven is in operation.
Open the main gas supply to the appliance. Connect the plug
2.
in the socket. Open the oven door.
Push in the switch for the lower gas burner and turn it to
3.
270 °C.
While holding the switch for the oven's lower gas burner
4.
depressed, press the ignition button
The gas escaping from the oven's lower gas burner is ignited
5.
using the ignition button. To activate the safety pilot, press
and hold the lower gas burner on the oven for 10 seconds.
Look through the inspection port to make sure that the flame
6.
is lit. If it is not, repeat the process from step 3.
Close the oven door slowly.
7.
Turn off the switch for the lower gas burner after 30 minutes.
8.
.
8

Setting the gas grill

Open the top cover. The top cover must remain open for as
1.
long as the cooker is in operation.
Turn on the main gas supply to the appliance. Insert the plug
2.
into the socket.
Insert the protecting plate into the groove below the control
3.
panel.
Insert the protecting plate with the longer edge at the front
and the curvature at the bottom.
Secure the protecting plate in the groove below the control
panel using the retainers.
Ensure that the protecting plate is engaged in the retainers. If
the protecting plate cannot be pulled out, it is engaged
correctly. You can now safely use the protecting plate. If it
can be removed, insert it into the groove at a slightly higher
angle and make sure that it engages in the retainers.
Close the oven door so that it is as close as possible to the
4.
protecting plate.
Push in the function selector and turn it clockwise to the grill
5.
setting .
#
Keep the function selector pressed in and press the ignition
6.
button at the same time.
8
The gas coming from the gas grill is ignited using the ignition
7.
button. Keep the function selector pushed in for 10 seconds
so that the safety pilot starts up.
Check whether the flame is lit. If the flame goes out, repeat
8.
the process from step 5.
Switch off the function selector after 30 minutes. Once the
9.
oven has cooled down, remove the protecting plate.
Caution!
The gas grill only works when the protecting plate is inserted.
Make sure that the protecting plate is correctly inserted.

Cleaning the accessories

Before you use the accessories for the first time, clean them
thoroughly with hot soapy water and a soft dish cloth.
13