Using A Handset As A Room Monitor - Siemens Gigasrt C590 User Manual

Using a handset as a room monitor

Using a handset as a
room monitor
If the room monitor is activated, a previ-
ously saved destination number is called
as soon as a set noise level is reached. You
can save an internal or external number in
your handset as the destination number.
All of the handset keys are deactivated,
with the exception of the display keys.
The room monitor call to an external
number is terminated after approximately
90 seconds. The room monitor call to an
internal number (handset) stops after
approx. 3 minutes (depending on the
base). When the room monitor is acti-
vated, all keys are locked except the end
call key. The handset's speaker is muted.
When the room monitor is activated,
incoming calls to the handset are indi-
cated without a ringtone and are only
shown on the screen. The display and key-
pad are not illuminated and advisory
tones are also turned off.
If you accept an incoming call, the room
monitor is suspended for the duration of
the call, but the function remains acti-
vated.
If you deactivate then reactivate the hand-
set, the room monitor remains activated.
54
Warning!
u
You should always check the
operation of the room monitor
before use. For example, test its
sensitivity. Check the connection
if you are diverting the room
monitor to an external number.
u
When the function is switched on,
the handset's operating time is con-
siderably reduced. If necessary,
place the handset in the base/charg-
ing cradle. This ensures that the bat-
tery does not run down.
u
Ideally the handset should be posi-
tioned 1 to 2 metres away from the
baby. The microphone must be
directed towards the baby.
u
The connection to which the room
monitor is diverted must not be
blocked by an activated answering
machine.
Activating the room monitor and
entering the destination number
É
¢ ¢
v
Room Monitor
¤
Change multiple line input:
Activation:
Select to activate.
On
Alarm to:
Select Internal or External.
External number: Select the number
from the directory (press display key
ö
) or enter it directly.
Internal number: Select display key
¢
Select handset or
§Change§
you want to call all registered handsets
¢
.
§OK§
In idle status, the destination number
or the internal destination number is
displayed.
¤
Press to save the settings.
§Save§
if
Call All