Remote Control - Sharp XL-DV100NH Operation Manual

System connections (continued)
■ Speaker connection
Connect the black wire to the minus (–) terminal, and the
red wire to the plus (+) terminal.
Caution:
●
Use speakers with an impedance of 6 ohms or more, as
lower impedance speakers can damage the unit.
●
Do not make a mistake when
connecting the right
speakers. The right speaker is the
one on the right side when you face
the unit.
●
Do not let the bare speaker wires
touch each other.
●
Do not allow any objects to fall into or
to be placed in the bass reflex ducts.
●
Do not stand or sit on the speakers.
You may be injured.

Remote control

■ Battery installation
1 Open the battery cover.
2 Insert the supplied batteries according to the direction
indicated in the battery compartment.
When inserting or removing the batteries, push them
towards the battery terminals.
3 Close the cover.
Precautions for battery use:
●
Replace all old batteries with new ones at the same
time.
●
Do not mix old and new batteries.
●
Remove the batteries if the unit will not be used for long
periods of time. This will prevent potential damage due
to battery leakage.
Caution:
●
Do not use rechargeable batteries (nickel-cadmium
battery, etc.).
●
Installing the batteries incorrectly may cause the unit to
malfunction.
●
Batteries (battery packed or batteries installed) shall
not be exposed to excessive heat such as sunshine,
fire or the like.
Battery removal:
Open the battery cover and pull up the battery to take out.
and left
Incorrect
■ AC power connection
After checking all the connections have been made
correctly, plug the AC power lead of this unit into the wall
socket. If you plug in the unit first, the unit will enter the
stand-by mode.
Note:
Unplug the AC power lead from the wall socket if the unit
will not be in use for a prolonged period of time.
■ Connecting iPod to a TV
The iPod with photo and video can be viewed by
connecting to a TV/monitor.
If the TV/monitor has a video input, connect it to the VIDEO
OUT socket on the rear of the unit.
Notes:
●
iPod video can only be played through VIDEO OUT
socket only.
●
Please make sure to set iPod unit to either NTSC or
PAL to match your TV signal. Please visit Apple's
homepage for further information.
Notes concerning use:
●
Replace the batteries if the operating distance is
reduced or if the operation becomes erratic. Purchase
2 "AAA" size batteries (UM-4, R03, HP-16 or similar).
●
Periodically clean the transmitter on the remote control
and the sensor on the unit with a soft cloth.
●
Exposing the sensor on the unit to strong light may
interfere with operation. Change the lighting or the
direction of the unit if this occurs.
●
Keep the remote control away from moisture, heat,
shock, and vibrations.
■ Test of the remote control
After installing the unit (see pages 6 - 7), check that the
remote control operates correctly.
Point the remote control directly at the remote sensor on
the unit.
The remote control can be used within the range
shown below:
Remote sensor
0.2 m - 6 m
(8" - 20')
ON / ON /
STAND-BY STAND-BY
E-7
ON / ON /
STAND-BY STAND-BY OPEN / CLOSE OPEN / CLOSE
1 2 3
4 5 6
7 8 9
DIRECT DIRECT
0 10 10
TUNING TUNING TUNING TUNING
PRESET PRESET PRESET PRESET
SETUP SETUP OSD/(TV OUT) OSD/(TV OUT) AUDIO AUDIO
EQUALIZER
(X-BASS) VOLUME CLOCK / TIMER
MEMORY SLEEP
TOP MENU MENU/PBC
ENTER
SUB TITLE