Table of Contents
Advertisement
42
5
Install the LP pilot orifice following the directions below.
(a) Use a 7/16" open-end wrench to remove the pilot hood.
(b) Remove and discard the Natural Gas (NG) orifice. Place the LP orifice in the pilot assembly then
replace the pilot hood, tightening the pilot hood until it is snug (do not over-tighten).
a
6
Replace the firebox components. Install the logs and embers. Replace the glass.
7
Carefully remove the control cover to access the stepper motor (see the illustrations below). The
stepper motor (adjustable regulator) has an installation sheet included with it – make sure to follow all
of the directions. Disconnect the wiring from the stepper motor. Remove the stock stepper motor
and replace with the LP version. – MAKE SURE IT IS CORRECTLY ORIENTED. Secure using the
screws included with the motor – tighten to 25 Lb-inches. Leak test this area after installation to
verify proper installation. Re-attach the wiring.
8
Make the gas line connection, bleed the gas line (if applicable), start the heater and thoroughly leak-
test all gas connections and the gas control valve.
© Travis Industries
Optional Equipment
Natural Gas Orifice = .020N (3way)
.018N (2way)
LP (Propane) Orifce = .014LP
7/16" Wrench
4120308
b
.020N
or
.018N
.014LP
100-01288_000
Advertisement
Table of Contents
