Siemens HL 62054 Instruction Manual page 43

If the oven is to switch on
and off automatically. The
time must be set on the
electronic clock.
Note
Please note:
During the last 30 minutes of the program, the oven
no longer heats and the oven lighting switches off.
This applies to all programs. These 30 minutes are
required so that your stew turns out juicy. Only then
can you take the dish out of the oven.
To correct:
Switch off the function selector and reset.
When the time has elapsed, a signal sounds for
approximately ½ minute. The P symbol flashes in the
display. Switch off the function selector.
Only use fresh meat for this. Do not leave it to stand in
the oven for too long. Meat will spoil easily when not in
the refrigerator.
Make the settings as described in points 1 to 5.
6.
Press the ! end button.
The time when the program will switch off appears
in the display. Change this time within the next six
seconds to a later time.
7.
Use the knob to set the new switch off time.
The current time is displayed again. The oven is in
standby mode.It will automatically switch on and off at
the correct time.
To correct:
Switch off the function selector and reset.
q If you wish to call up the remaining cooking time,
the end time, the set program number or the
weight, press the appropriate button: ? cooking
time, ! end time, the program or weight. The
information you require will be displayed for six
seconds.
When the time has elapsed, a signal sounds for
approximately ½ minute. The P symbol flashes in the
display. The stew is ready. Switch off the function
selector.
43