Table of Contents
Advertisement
Be careful in realigning the color wires. Any error here will cause serious damage to the
Internal Multi-Card Reader.
c.
Keep the same side of the wire pins facing up and insert them back into the connector.
Press the tab down to fully seat the wire pins.
6. Connect the USB connector of the Internal Multi-Card Reader to the USB pin-header on the
motherboard. The hardware setup is complete.
After the driver installation and hardware setup is complete, you can power on the computer and
start to use your Internal Multi-Card Reader.
To Use with Windows 98SE and 2000
1. Power on the computer. The New Hardware Found window will appear (the first time you
power on the computer after installing the Internal Multi-Card Reader).
To Use the Internal Multi-Card Reader
Wire
Red
White
Green
Black
Thick Black
Not Connect / Shield Ground
6
Pin Assignment
Vcc / Power / +5V
P-, Data-
P+, Data+
GND
Advertisement
Table of Contents
