Installation Of The Appliance - Smeg PLDA21AC Instructions For Installation And Use Manual

Table of Contents

Advertisement

Instructions for the installer

2. INSTALLATION OF THE APPLIANCE

The following operation requires building and/or carpentry work so must
be carried out by a competent tradesman.
Installation can be carried out on various materials such as masonry,
metal, solid wood or plastic laminated wood as long as they are heat
resistant (T 90°C).
2.1 Attachment to support structure
Create an opening with the dimensions
shown in the figure in the top surface of
the
distance of 50 mm from the rear border.
This appliance is classified as "type Y" in
relation to fire hazards and can therefore
be mounted against walls higher than
the work surface on condition that a
certain distance "X" be kept between the
appliance and the wall as shown in the
figure so as to avoid damage from
overheating.
Make sure there is a minimum of 750 mm between the hot plate flames
and any shelf that may be installed directly above them.
To fix the appliance to the worktop,
insert the 4 fixing brackets (A) as
shown in the diagram until they fit
securely into place.
Then use 4 self-tapping screws to
fix the appliance to the worktop
through the slots B.
Overall dimensions: location of gas and electrical connection points (all
measures in mm).
6
counter,
keeping
1
a
minimum
PSA9R
A
44
B
147
C
68
D
128

Advertisement

Table of Contents
loading

This manual is also suitable for:

Plda24Plsa21acPlsa24Psa9r

Table of Contents