Gigaset S810H User Manual page 10

First steps
Attaching the belt clip
The handset has notches on each side to attach the belt clip.
¤ To attach – press the belt clip onto
the back of the handset so that the
protrusions on the belt clip engage
with the notches.
¤ To remove – press the centre of the
belt clip firmly with your right
thumb, push the fingernail of your
left index finger up between the
clip and the housing and pull the
clip in an upward direction.
Initial charging and discharging of the batteries
The correct charge level can only be displayed if the batteries are first fully charged and
discharged.
8.5 h
¤ After charging, remove the handset from the charging cradle and only replace it
when the batteries are fully discharged.
Please note
u After the initial battery charge and discharge, you may place your handset in the
base after every call.
u Always repeat the charging and discharging procedure if you remove the batter-
ies from the handset and reinsert them.
u The batteries may warm up during charging. This is not dangerous.
u After a while, the charge capacity of the batteries will decrease for technical rea-
sons.
8
Charge the handset in the charging cradle for 8.5 hours.
Please note
The handset must only be placed in the designated Gigaset S810/
S810A base or charging cradle.