Charge Battery - Siemens MC60 Operating Instructions Manual

Charge battery

The battery is not fully charged
when delivered. Plug charger cable
into the bottom of the phone, plug
power supply unit into a mains
power socket and charge for at least
two hours.
Display when charging is in progress
During charging.
h
Charging time
An empty battery is fully charged
after about 2 hours. Charging is only
possible within a temperature range
of +5 °C to +40 °C.
If the temperature rises/falls 5 °C
above/below this, the charge symbol
flashes a warning. The mains voltage
specified on the power supply unit
must not be exceeded.
Getting started
Charge icon not visible
If the battery has been discharged
fully the charge icon is not
immediately visible when the power
supply unit is plugged in. It will
appear after up to two hours. In this
case the battery is fully charged after
3-4 hours.
Only use the power supply unit supplied!
Display while in service
Charge level display during
operation (empty-full):
a d g
A beep sounds when the battery is
nearly empty. The charge level of the
battery is only displayed correctly
after an uninterrupted
charging/discharging cycle.
You should therefore not remove the
battery unnecessarily and where
possible not terminate the charging
process before completion.
Additional information
The power supply unit heats up when used
for long periods. This is normal and not
dangerous.
If the battery is removed for longer than
30 seconds, the clock must be reset.
9