Replacing Fuse - Yamaha F200C Owner's Manual

EMU01830

REPLACING FUSE

If the fuse has blown on an Electric start
model, open the fuse box and replace the
fuse with a spare one of proper amperage,
using a fuse puller.
WARNING
@
Be sure to use the specified fuse. An
incorrect fuse or a piece of wire may
allow excessive current flow. This could
cause electrical system damage and a
fire hazard.
@
CAUTION:
@
G If a main fuse has blown, be sure to
also check the other main fuse.
G If the outboard motor is operated after
a main fuse has blown charging capa-
bility will be insufficient, and the
engine will not start.
@
NOTE:
@
If the new fuse blows again immediately,
consult a Yamaha dealer.
@
1 Fuse box
2 Fuse (5A × 1, 20A × 2, 30A × 5)
3 Spare fuse (5A, 20A, 30A)
4 Fuse puller
5 Starter relay
6 Main fuse 2
7 Main fuse 1
8 Fuel feed pump
9 Main switch / Trim switch
0 Engine control unit / Ignition coil / Fuel injec-
tion pump / Fuel injection nozzle / ISC (idle
speed control)
A Accessory fuse 2
B Accessory fuse 1
4-21
E