Yamaha MT4X User Manual page 38

37 Synchronization
Set the connected MIDI instrument to FSK sync mode, to receive the FSK signals
from the MT4X. Set any other connected MIDI instruments to MIDI clock mode to
slave to the MIDI device receiving the FSK signals. Perform any other required
setup on your MIDI instruments to ensure they perform correctly once the MT4X
starts playing the FSK signals.
Please refer to the instruction manual supplied with your MIDI instrument for
further setup details.
2) Connect your MIDI instrument(s) to a monitor mixer. Then connect the input source
for each channel to the corresponding MIC/LINE INPUT connector.
Adjust the input and monitor levels. See "Overdubbing" on page 19.
Tip: You may find it easier to have just one monitor channel to adjust. Plug a cable
between the MONITOR OUT connectors and the input channels of the monitor mixer.
3) Press the REC SELECT keys for the tracks you want to record.
The corresponding REC SELECT - TRACK indicator on the display will flash.
4) If dbx™ system is on, press the SYNC key. The SYNC indicator will light.
Rehearsal
5) Press the REHE key to put the MT4X into rehearsal mode.
6) Press the PLAY key to start playback.
The MIDI instrument(s) will playback in sync with the data recorded on track 4.
Note: If the MIDI instrument does not play correctly, you probably started the tape at
a point after the FSK signal began. You must ensure the tape plays back from before the
start of the FSK track.
User's Guide