Yamaha MT4X User Manual page 24

23 Recording Functions
The AUTO PUNCH and START indicators
above the REHE key will begin flashing.
Note: The AUTO PUNCH indicator will either be flashing or illuminated while the
automatic punch-in/out function is active.
4) Press the PLAY key (or step on the footswitch) to play the tape.
The START indicator will light and the IN indicator will begin flashing. The
indicator above the REC/PAUSE key will flash rapidly.
Note: You can reverse the order of steps 3 and 4. In this case, you would mark the start
point while playing by pressing the AUTO PUNCH I/O key.
5) At the punch-in location, press the REC/PAUSE key (or step on the footswitch).
The START indicator will switch off, the IN indicator will light, the OUT indicator
will begin flashing, and the punch-in point will be stored. The indicator above the
PLAY key will flash rapidly.
6) At the punch-out location, press the PLAY key (or step on the footswitch).
The IN indicator will switch off, the OUT indicator will light, and punch-out point
will be stored.
Ten (10) counts on the tape counter (at 9.5 cm/sec - 5 counts at 4.8 cm/sec) after the
punch-out location becomes the post-roll point. The OUT indicator will switch off,
the START indicator will begin flashing, and the tape is automatically rewound
back to the pre-roll point.
When tape is rewound, the AUTO PUNCH and START indicators will light and the
indicator above the REHE key will flash rapidly.
on the display and the indicator
User's Guide