Yamaha MT4X User Manual page 10

9 Controls and Connections
REC SELECT keys
These keys are used to arm the tracks for recording. When you press a REC SELECT
key/ the record select indicator
multi-function display
REPEAT key
This key is used to start and cancel the repeat function. When the repeat function is
active, the MT4X will repeatedly playback a selection between two memory points
set with the MEMO keys
When the automatic punch-in/out function is active, the REPEAT key causes the
MT4X to immediately start the rehearsal mode. See "Using the automatic punch-in/
out function" on page 21.
Note: The repeat interval must be more than three counts on the tape counter
RETURN TO ZERO key
This key rewinds the tape to the point where the tape counter
The tape counter flashes while the tape rewinds.
dbx key
This key is used to turn the dbx noise reduction system on and off. By default, the
dbx™ system is turned on when the MT4X is first powered on.
The dbx™ system has no effect on track 4 when the SYNC key
recording" on page 35.
SYNC key
This key defeats the dbx™ noise reduction system on track 4. This allows you to
record FSK signals onto the track. See "FSK recording" on page 35.
CLEAR key
This key clears the stored memory points. When automatic punch-in/out is active
(the AUTO PUNCH indicator
(but does not clear the memory points).
AUTO PUNCH I/O key
This key is used to start and cancel the automatic punch-in/out function. See
"Using the automatic punch-in/out function" on page 21.
CHECK key
This key is used to verify the memory points. Press and hold this key and the press
one of the MEMO keys
and the stored value will be shown on the tape counter
MEMO (1,2) keys
These keys store the current tape counter
press one of these keys, the corresponding MEMO indicator
point stored.
You can clear the memory points by pressing the CLEAR key
cassette tape, or turning off the power.
for the corresponding track flashes on the
. See "Repeat Function" on page 42.
is illuminated), this key clears the current setting
The corresponding MEMO indicator
value as memory points. When you
reads "0000".
is on. See "FSK
will flash
will light and the
removing the
User's Guide