Yamaha MT4X User Manual page 25

Rehearsal
The MT4X automatically enters rehearsal mode after you have assigned the punch-in and
punch-out points. This mode allows you to practice the punch-in/out operation before
you actually commit anything to tape.
Note: In this mode, you can press the REPEAT key
will automatically perform rehearsal playback between the pre-roll point and the post-roll point.
For more detail, see "Repeat Function" on page 42.)
7) Press the MONITOR SELECT - CUE key. Adjust the CUE LEVEL controls for the
selected tracks. Set the monitor volume with the MONITOR/PHONES level
control.
8) Press the PLAY key (or step on the footswitch) to play the tape.
At the punch-in location, the START indicator will switch off, the IN indicator will
light, and the indicator above the REHE key will light. If you are monitoring the cue
bus, the sound will switch from the tape to the input source.
At the punch-out location, the IN indicator and indicator above the REHE key will
switch off, the OUT indicator will light, and monitor source will switch back to the
tape.
At the post-roll point, the OUT indicator will switch off, the START indicator will
begin flashing, and the tape is automatically rewound back to the pre-roll point.
When tape is rewound, the AUTO PUNCH and START indicators will light and the
indicator above the REHE key will flash rapidly.
If you are satisfied with the working points, you can move on to the next operation,
the actual recording. Otherwise, press the CLEAR key
repeat steps 3 to 6.
Recording
9) Press the REC/PAUSE key.
The indicator above the REHE key will switch off and the indicator above the REC/
PAUSE key will flash rapidly.
Note: If you skipped step 2, you need to use the REC SELECT key(s) to select a track
(or tracks) before you record.
User's Guide
Recording Functions
to start Repeat Rehearsal. The MT4X
to clear the points and
24