Siemens HB280 Series Operating Instructions Manual page 28

Cleaning catalytic enamel
Cleaning the remaining
enamel surfaces
28
3.
Open the door wide enough to pull it upwards and
out.
When replacing the oven door, ensure that the notch
engages correctly under the hinge.
The roof and the back wall of the oven are coated with
a layer of catalytic enamel. The surfaces clean
themselves while the oven is in operation. If a large
amount of spillage occurs, the oven may have to be in
operation several times before it has fully cleaned itself
again. Remains from herbs and spices etc. can be
removed with a dry cloth or soft brush.
Do not use oven cleaner.
Should the enamel become slightly stained, this will
not affect its self cleaning properties.
Wipe away minor spillages from the oven floor and
side walls using warm soapy water or vinegar solution.
It is best to use oven cleaner if the oven floor and side
walls are very dirty.
q Only use oven cleaner in a cold oven.
q Spray on the cleaner and allow it to take effect.
NB: Only spray on the oven floor and the side
walls.
In the case of remains that are difficult to remove,
heat the oven up to 50 ºC for a maximum of
2 minutes no longer, otherwise the enamel will
become stained.