Specifications; Unpacking; Initial Set Up Instructions; Assembly - Central Machinery 97181 User Manual

speciFications

Construction Materials
Sanding Disc
Sanding Belt
Motor and Electrical
Information
Plug
Belt Speed
Disc Speed

unpackinG

When unpacking, check to make sure
that the item is intact and undamaged. If
any parts are missing or broken, please
call Harbor Freight Tools at the number
shown on the cover of this manual as soon
as possible.
initial set up
instructions
read the entire iMportant
saFetY inForMation section
at the beginning of this manual
including all text under
subheadings therein before set
up or use of this product.
SKU 97181
Housing: Sheeted
Steel
Roller and Block
Stop: Polyethylene
Hardware: Carbon
Steel
Feet: Rubber
6"
4" W X 36" L , 80 Grit
3/4 HP PEAK
120V
60Hz,
Amps - With Load:
3.5 AMP'S
3-Prong Grounded
1150 FPB
1780 RPM
For technical questions, please call 1-800-444-3353.
warninG
accidental operation:
turn the power switch of the
belt/disc sander to its "oFF"
position and unplug the tool
from its electrical outlet
before assembling or making
any adjustments to the tool.
note: For additional information regarding
the parts listed in the following pages,
refer to the Assembly Diagram near
the end of this manual.

asseMblY

Feet placement

1. Carefully set the Belt/Disc Sander on
its side.
Figure 1
Rubber Pads (28)
2. Press each Rubber Pad (28) over the
lip of the Base at each corner. (See
Figure 1)
to preVent
serious injurY
FroM
Page 9