Specifications; Setup; Operation - Central Machinery 69257 Owner's Manual

Specifications

3092372
Setup - Before Use:
Read the ENTIRE IMPORTANT SAFETY INFORMATION section at the beginning of this
manual including all text under subheadings therein before set up or use of this product.
TO PREVENT SERIOUS INJURY FROM ACCIDENTAL OPERATION:
Turn the Power Switch of the tool off and unplug the tool from its electrical
outlet before performing any procedure in this section.
Note: For additional information regarding the parts listed in the following pages,
refer to the Assembly Diagram near the end of this manual.
Mounting Sander
1. Select a mounting location that is able to
support the weight of the Sander, plus any
additional weight placed on it during use.
2. Make sure there are no hidden electric wires,
cables or other obstructions that may interfere
with the mounting procedure or cause a hazard.
Installing Dust Collector
Attach a dust collection system (not included) to the dust port.
Functions
Sanding Drum
Table Insert
Table Top
Safety Key
Power Switch
Page 6
Electrical Rating
Motor No Load Speed
Speed
Stroke
Table Top
Knob
Spindle
Sanding Sleeve
Dust Port
Figure A
For technical questions, please call 1-800-444-3353.
120V~ / 60Hz / 2.6A
1725 RPM
30 OPM
5/8"
14" diameter
3. Mark the mounting hole locations and
drill the appropriate size holes for the
mounting bolts (not included).
4. Mount the Sander using Bolts, washers
and nuts (not included).
Accessories
1/2" 1/2" 3/4" 3/4"
Drum
Washer
Spindle
Drum
Sanding
Sleeve
Table
Insert
Call
1-800-444-3353
to order sleeves as
replacement parts.
1" 1" 1½" 1½" 2" 2" 3" 3"
Item 69257