Carbon Brush Replacement - Central Machinery 32650 Set Up And Operating Instructions Manual

Bolts
(35)
Motor
Bracket
(36)
Figure 28
5. Remove the old Belt (34) and place a
new belt on the Pulleys (3e and 38).
6. If the tension needs adjusting:
a. Loosen the four hex head Bolts (35) on
the Motor Bracket (36).
b. Slide the bracket up or down until the
sides of the belt are tight.
c. Tighten the bolts and make sure the belt
runs straight.
nOTe: Never over-tension belt as this will
result in shortened motor bearing life.
7. Replace the belt guard and turn the
machine right side up.

carbon Brush replacement

Replacement Carbon Brushes (3b)
are included with this unit. The Carbon
Brushes should be replaced by a
qualified technician.
reV 10e
SKU 32650
Spindle
Pulley
(38)
Belt (34)
Motor
Pulley
(3e)
For technical questions, please call 1-800-444-3353.
Bolts
(35)
Page 21