Removing Or Installing The Shaper Spindle - Central Machinery 32650 Set Up And Operating Instructions Manual

removing or installing the Shaper
The Shaper/Router is packaged with the
Shaper Spindle (47) installed so that the
unit is ready for use as a shaper. To use
the unit as a router, the Shaper Spindle
must be removed. Reinstall the Shaper
Spindle when using shaper cutters.
To remove the Shaper Spindle:
Shaper Spindle (47)
Shaper
Spindle
Nut (46)
Spindle
Wrench
(54)
Main
Spindle
(43)
a) Hold Main Spindle
Figure 7
H old the Main Spindle (43) with the
Spindle Wrench (54) and the Shaper
Spindle Nut (46) with the Double Ended
Wrench (55). Turn the Double Ended
Wrench counter clockwise to unthread
the Nut from the Main Spindle.
note: Insert the Spindle Wrench from under
the Table Top (7) and the Double Ended
Wrench from above the Table Top. You
may need to adjust the Main Spindle
height for easier access.
reV 10e
SKU 32650
Spindle
b) Turn Counter-
clockwise
For technical questions, please call 1-800-444-3353.
To install the Shaper Spindle:
Thread the fine threaded end of the Nut (46) onto
Shaper
Spindle
Nut (46)
Figure 8
1. Thread the Shaper Spindle Nut (46) onto
the Spindle. The Nut has one end with
fine threads and the other with course
Double
threads. Match the fine threads with the
Ended
Wrench
Shaper Spindle. (The course threads fit
(55)
the Main Spindle (43)). BE CAREFUL
NOT TO SCREW THE NUT ONTO THE
SHAPER SPINDLE WITH THE COARSE
THREADS OR YOU WILL DAMAGE
BOTH PARTS. Thread the Nut onto the
Shaper Spindle until the threads of the
Spindle reach the coarse threads of the
Nut.
Figure 9
2. Insert the Shaper Nut/Spindle assembly
onto the Main Spindle (43). Hand tighten
the Nut onto the Main Spindle threads
clockwise.
this end of the Spindle (47).
Shaper Spindle (47)
Fine Threads
Course Threads
Shaper Spindle (47)
Shaper Spindle
Nut (46)
Main Spindle (43)
Table Top (7)
Page 11