Installing Router Bits - Central Machinery 32650 Set Up And Operating Instructions Manual

4. Slide the Washer (13) and the Keyed
Washer (48) onto the Shaper Spindle,
and thread the Nut onto the end of the
Shaper Spindle.
Spindle Wrench (54)
Shaper Spindle (47)
Nut (49)
Cutter
(sold separately)
Figure 13
5. Use the Spindle Wrench (54) to hold the
Shaper Spindle in place while tightening
the Nut clockwise with the small end of
the Double Ended Wrench (55).
Warning! The Keyed washer must be
directly under the Nut (49) or else
serious injury may occur. Be careful to
tighten the Nut (49) and the Height Knob
(16) securely.

installing router Bits

1. Remove the Shaper Spindle (47) if it is
installed.
reV 10e
SKU 32650
Double
Ended
Wrench
(55)
For technical questions, please call 1-800-444-3353.
Router Collet Nut (51)
Router Bit
Collet (50)
Main Spindle (43)
Figure 14
2. Insert the Router Bit Collet (50) into the
Main Spindle (43).
3. Place the Router Collet Nut (51) over the
Router Bit Collet and thread it clockwise
so that it is loosely in place on the Main
Spindle.
4. Insert the Table Insert (8).
Router Bit
(sold separately)
Router Collet Nut (51)
Figure 15
5. Insert the router bit (sold separately) into
the Main Spindle.
6. Firmly tighten the bit in place by turning
the Router Collet Nut (51) clockwise
with the Double Ended Wrench (55)
Router Bit
(sold separately)
Table Top (7)
Table Insert
Table Top (7)
Page 13