Panasonic LUMIX DMC-TS1 Operating Instructions Manual page 36

} [SCENE MENU]
[VERSION DISP.]
[FORMAT]
•
Use a battery with sufficient battery power or the AC adaptor (optional) and multi conversion
adaptor (optional) when formatting. Do not turn the camera off during formatting.
•
If a card has been inserted, only the card is formatted. To format the built-in memory, remove
the card.
•
If the card has been formatted on a PC or other equipment, format it on the camera again.
•
It may take longer to format the built-in memory than the card.
•
If you cannot format, contact the dealer or your nearest Service Centre.
~ [LANGUAGE]
•
If you set a different language by mistake, select [~] from the menu icons to set the desired
language.
[DEMO MODE]
DEMO
•
In playback mode, [JITTER, SUBJ. MOVE DEMO.] cannot be displayed.
•
Press [DISPLAY] to close [JITTER, SUBJ. MOVE DEMO.].
Press [MENU/SET] to close [AUTO DEMO].
•
[JITTER, SUBJ. MOVE DEMO.] is an approximation.
•
[AUTO DEMO] has no TV output capability even when it is in playback mode.
Preparation
Set the screen that is displayed when the mode dial is set to
[OFF]: The recording screen in the currently selected scene
mode appears.
[AUTO]: The scene mode menu screen appears.
It is possible to check which version of
firmware is on the camera.
The built-in memory or card is formatted. Formatting irretrievably
deletes all the data so check the data carefully before formatting.
Set the language displayed on the screen.
The camera automatically detects jitter and the movement of the
subject and displays these on the indicator. ([JITTER, SUBJ.
MOVE DEMO.])
The camera's features are displayed as slide shows. ([AUTO
DEMO])
[JITTER, SUBJ. MOVE DEMO.]
A Jitter detection demonstration
B Movement detection demonstration
[AUTO DEMO]:
[OFF]
[ON]
- 36 -
.
(P67)
A
B