Building And Equipment; Maintenance - Nilfisk-ALTO SOLAR BOOSTER EH Instruction Manual

5.7.3

Building and equipment

Task Accessories
General surfaces Foam injectors
Standard lance
Metallic equip- Curved lances
ment Tank cleaning head
Detergents
Intensive
J25 Multi
Combi Aktive
Alkafoam
Disinfectant
DES 3000
Rusted or dam- Wet sand blasting equip-
aged surfaces ment
prior to treatment
These are merely several examples of cleaning tasks that can be solved by a pressure washer in
association with accessories and detergents. Each cleaning task is different. Please consult your local
dealer or Nilfi sk-ALTO representative in order to discuss the best solution for your own cleaning tasks.

6 Maintenance

24
Method
1. Apply thick foam over the surfaces to be cleaned.
Apply on dry surfaces. Apply from top to bottom
on vertical surfaces. Let the foam act for up to 30
minutes for the optimal effect.
2. Proceed with cleaning using the high pressure
lance. Use applicable accessories. Use high pres-
sure to dislodge large amounts of incrusted dirt or
grime. Use lower pressure and high water volume
in order to rapidly fl ush away loose dirt and rinse
surfaces.
3. Apply DES 3000 disinfectant once the surfaces
are perfectly clean.
Areas covered by amounts of loose dirt, such as ani-
mal remains in slaughterhouses, can be removed by
using high water fl ow to fl ush away the dirt to evacu-
ation pits or drains.
Tank cleaning heads can be used to clean barrels,
vats, mixing tanks etc. Cleaning heads may be hy-
draulically or electrically powered and give the possi-
bility for automatic cleaning without a constant user.
1. Connect the sand blasting lance to the pressure
washer and place the suction tube in the sand.
2. Always wear protective equipment during sand
blasting.
3. Spray the surfaces to be treated with the mix of
water and sand. Rust, paint etc will be stripped
off.
To ensure the most optimal
maintenance of your SOLAR
BOOSTER, you should consid-
er making a "Service Contract"
with Nilfi sk-ALTO. In this way
your SOLAR BOOSTER will
always be ahead of potential
problems.
Though paying attention to a
few things will ensure a pro-
longed and reliable operation of
your Solar Booster. Therefore
it will be a good idea to make a
habit of the following:
Prior to attaching the water
hose and the high pressure
hose, the quick couplings
should be cleaned of dust and
sand. Flush if necessary. This
will prevent premature clogging
of fi lters.
Prior to attaching the spray
lance or other accessories to
the spray handle, the machine
should be started and the quick
coupling cleaned of dust and
sand.