Table of Contents
Advertisement
ª Replacing the Batteries
The life of the batteries is about 1 year.
When the batteries are exhausted, purchase two
new "AAA", "UM-4" or "R03" type batteries and
insert them in the same way as explained above.
≥Do not mix old batteries with new batteries.
≥Do not mix different battery types, i.e. Alkaline
and Manganese.
≥Do not use rechargeable (Ni-Cd) batteries.
≥Do not short-circuit the batteries.
≥When you do not use the Remote Controller
for a long time, take out the batteries and store
them in a cool, dry place.
ª Conditions for Correct Operation of
the Remote Controller
10˚
15˚
15˚
15˚
≥The distance to the Movie Camera must not
be more than 5 metres.
≥The Transmitter Window on the Remote
Controller or the Remote Control Sensor
on the Movie Camera must not be exposed to
direct sunlight and not be covered with
clothes, etc.
≥When operating the Zoom Function with the
Remote Controller, it is not possible to vary the
zooming speed. Also, there is a slight delay
between pressing the Zoom Buttons
the Remote Controller and the mechanical
zoom adjustment on the Movie Camera.
≥Within a distance of about 1 metre, it is also
possible to use the Remote Controller from the
side ([MENU] Button side).
Power Supply
ª Using the AC Adaptor
1
1
Detach the cap 2 from the plug of DC
Input Lead.
2
Connect the AC Adaptor to the [DC IN]
Socket
(33)
on the Movie Camera.
3
Connect the AC Mains Lead to the AC
Adaptor and the AC mains socket.
≥The AC Mains Lead's outlet plug does not fit
entirely into the AC Adaptor socket. A gap
will remain as shown 1.
Before Use
(5)
(5)
(40)
on
2
(33)
-34 -
≥After use, be sure to attach the cap 2 to the
plug of DC Input Lead.
≥Before connecting or disconnecting the
power supply, set the [CAMERA/OFF/VCR]
Switch on the Movie Camera to [OFF] and
make sure that neither [CAMERA] Lamp
nor [VCR/CHARGE] Lamp is lit.
≥Keep the AC Adaptor out of reach of children.
Do not put the plug of DC Input Lead into a
mouth. An electric shock may occur.
ª Using the Battery
Before use, fully charge the Battery.
1
Set the [CAMERA/OFF/VCR] Switch
[OFF].
CAMERA
OFF
VCR
(34)
2
Insert the Battery with its top (so that the
arrow points upward) into the top Battery
Holder
(25)
and press the bottom of it
toward the Movie Camera until it locks
with a click.
(25)
3
Connect the AC Adaptor to the [DC IN]
Socket
(33)
on the Movie Camera.
4
Connect the AC Mains Lead to the AC
Adaptor and the AC mains socket.
≥The [CHARGE] Lamp
(2)
charging starts.
(2)
CAMERA
V C R
CHARGE
≥When the [CHARGE] Lamp
charging is completed. After that,
disconnect the AC Adaptor.
2
(34)
to
(33)
flashes and
INFO-
WINDOW
(2)
goes off,
Hide quick links:
Advertisement
Table of Contents
